Article ID: 101927 - View products that this article applies to.
This article was previously published under Q101927
The Lmhosts file is a local text file that maps Internet Protocol (IP) addresses to NetBIOS names of remote servers with which you want to communicate over the TCP/IP protocol.
The Lmhosts file is located in the %SystemRoot%\System32\Drivers\Etc folder on a Windows computer. There is also a sample Lmhosts file (Lmhosts.sam) in this folder.
Windows recognizes names instead of IP addresses for network requests and a name discovery process is used to correctly route network requests with TCP/IP. Because the name discovery process is generally not routed by an IP router, the Lmhosts file allows Windows computers to communicate using TCP/IP across a subnet bridged by an IP router.
Under TCP/IP alone, NetBT (NetBIOS over TCP/IP) checks this list in memory before doing a b-node name discovery. For example, a reference to \\Eric is translated to reference the actual IP address of 22.214.171.124 (this is a fictional address).
Sample Lmhosts File126.96.36.199 Joe #PRE
188.8.131.52 Paul #PRE
184.108.40.206 Eric #PRE
220.127.116.11 Ed #PRE
NOTE: All addresses are fictional.
When Windows loads, it reads the first 100 entries, by default, in the Lmhosts file marked with #PRE. You can increase the number of #PRE entries that will load into memory at logon by adding the MaxPreLoad entry in the registry. This entry should be added to the following registry key:
HKEY_LOCAL_MACHINE\CurrentControlSet\Services\NetBT\ParametersThe maximum number allowed for MaxPreLoad depends on the performance of the system. Some computers are able to parse or search through more entries in the Lmhosts file than others. Based on system performance, Windows usually searches through about 1000 entries before it times out (15 seconds).
Article ID: 101927 - Last Review: February 20, 2007 - Revision: 2.2