Article ID: 252332 - View products that this article applies to.
This article was previously published under Q252332
When you perform a large amount of network file transfers to a server (enough to cause a reasonable amount of disk stress on the server), one or more instances of the following error message may be displayed in the client event logs:
As a result of these redirector timeouts, write operations to the server may be unsuccessful.
Error 3013, "The redirector has timed out to servername"
Redirector timeout error messages are generic errors that simply indicate that the server was not responding to the client before the redirector timeout period. Although there are many causes of redirector timeout errors, this error message can occur because of a cache manager problem on the server if the following conditions are met:
So far this problem has only been reproduced when you use Windows NT 4.0 clients to connect to a server running Windows 2000. This problem is mostly observed when the server is using either software or hardware RAID that slows down disk throughput such as RAID 5 (striping with parity).
To resolve this problem, obtain the latest service pack for Windows 2000. For additional information, click the following article number to view the article in the Microsoft Knowledge Base:
260910Note This is a server-side fix and the service pack should be applied to the servername server referred to in the 3013 error message to address this problem.
(http://support.microsoft.com/kb/260910/ )How to Obtain the Latest Windows 2000 Service Pack
Microsoft has confirmed that this is a problem in Windows 2000. This problem was first corrected in Windows 2000 Service Pack 1.
For additional information about other possible causes of 3013 error messages, click the article number below to view the article in the Microsoft Knowledge Base:
(http://support.microsoft.com/kb/148426/EN-US/ )Troubleshooting Event ID 3013
Article ID: 252332 - Last Review: February 20, 2007 - Revision: 3.6