The host access component of Microsoft Mail Gateway to PROFS and
OfficeVision uses two custom Gateway EXIT executables to set To and From
addresses on messages between the host and the MS mail systems.
Use this query to verify that the EXITs are properly installed and
enabled:
SM MSRSCS Q SYS EXIT
If all is well, the system responds:
EXIT 2 enabled
EXIT 15 enabled
If you have problems with the EXITs, do this:
| 1. | Make sure the EXITs are being turned on in the MSRSCS machine's
RSCS CONFIG file. Look for these two lines:
EXIT 2 ON CSIEXIT2
EXIT 15 ON CSIEXITF |
| 2. | Make sure your RSCS system has the correct EXITs installed. Use
COMPARE to match the CSIEXIT LOADLIB installed on the MSRSCS's 191
disk against the CSIEXIT2 and CSIEXIT3 LOADLIBs on the 193 disk.
If you find discrepancies, copy the EXITs from the VMID's 193 disk.
If you think an EXIT is corrupt, upload an original version from the
installation diskettes. |
Host Access and Distribution Manager for IBM PROFS and OfficeVision: VM
Administrator's Guide.
This article was written about products for which Microsoft no longer offers support. Therefore, this article is offered "as is" and will no longer be updated.
Help and Support
Back to the top
