Article ID: 112841 - View products that this article applies to.
This article was previously published under Q112841
The COM port settings in the Ports option of Control Panel have no effect on COM port settings used in a command prompt window.
MODE.COM queries the port directly. Default settings are the following:
Status for Device COM1: ----------------------- Baud: 1200 Parity: Even Data Bits: 7 Stop Bits: 1 Timeout: OFF XON/XOFF: OFF CTS handshaking: OFF DSR handshaking: OFF DSR sensitivity: OFF DTR circuit: ON RTS circuit: ON
Applications reset the mode of the COM port(s). If, for example, you start Terminal and reset COM1 to 14400 baud, 7 data bits, odd parity, then exit Terminal, the new settings remain in effect until the computer is shut down. Upon rebooting, the default settings are once again in effect. The Control Panel settings, on the other hand, affect the registry. An application that is appropriately written can query the registry for these values and use the Control Panel settings. The default settings in the Ports option of Control Panel are:
Settings for COM1: ------------------- Baud Rate: 9600 Data Bits: 8 Parity: None Stop Bits: 1 Flow Control: None
Article ID: 112841 - Last Review: February 20, 2007 - Revision: 2.2
Contact us for more help