Article ID: 120388 - View products that this article applies to.
This article was previously published under Q120388
This article has been archived. It is offered "as is" and will no longer be updated.
During the installation of Windows 95, you receive the following error message:
Setup Detection Warning
Setup has found a hardware device on your computer that is not responding. Click Continue to try this device again.
If problems persist, click Exit Setup, quit all programs, remove floppy disks from their drives, and turn your computer off. Then, turn your computer on and run Setup again (choose Safe Recovery when prompted).
This error message can be caused by any of the following conditions:
Following the recommendation in the error message (that is, turning off your computer, turning on your computer, and then rerunning Setup selecting Safe Recovery) may correct this problem. If it does not, you must determine which of the above conditions exists and then correct the problem (or problems).
Article ID: 120388 - Last Review: September 13, 2013 - Revision: 1.1
Contact us for more help
Connect with Answer Desk for expert help.