Event IDs 4307 and 4311 Occur After Disabling WINS Bindings

Article translations Article translations
Article ID: 123981 - View products that this article applies to.
This article was previously published under Q123981
Expand all | Collapse all

SYMPTOMS

After you attempt to disable the WINS bindings for a network interface card (NIC) in the Control Panel Network dialog box, Event Viewer reports two errors:
Event ID 4307: Initialization failed because the transport refused to open initial Addresses.

Event ID 4311: Initialization failed because the driver device could not be created.

CAUSE

These errors occur when you disable all WINS related bindings and Show Binding For is set to < All Components >. They may also occur due to an incorrect order of the bindings.

RESOLUTION

To correct this problem:

  1. In the Show Bindings For list box, choose WINS Client(TCP/IP).
  2. Select the WINS binding shown and choose Enable.
  3. Verify that the WINS bindings are above any RAS bindings in the list (lower all RAS bindings to the bottom of the list).
  4. Choose OK and then choose OK again.
If enabling the bindings does not correct the problem, remove the TCP/IP protocol completely, and then reinstall it.

Properties

Article ID: 123981 - Last Review: October 31, 2006 - Revision: 3.1
APPLIES TO
  • Microsoft Windows NT Workstation 3.5
  • Microsoft Windows NT Server 3.5
Keywords: 
kbnetwork KB123981
Retired KB Content Disclaimer
This article was written about products for which Microsoft no longer offers support. Therefore, this article is offered "as is" and will no longer be updated.

Give Feedback

 

Contact us for more help

Contact us for more help
Connect with Answer Desk for expert help.
Get more support from smallbusiness.support.microsoft.com