Cannot Install/Upgrade Windows 95 from GUI on IBM Aptiva 710

Article translations Article translations
Article ID: 132186 - View products that this article applies to.
This article was previously published under Q132186
Expand all | Collapse all

SYMPTOMS

When you try to reinstall or upgrade the copy of Windows 95 on an IBM Aptiva 710 computer, you may receive the following error message while Setup is analyzing the computer:
Setup: Error SU0507

The following problem occurred while Setup was analyzing your computer:
SDMErr(8037001b): Detection function returned a DMS error.
DMSError: This computer cannot be upgraded from Windows. Please shutdown Windows and upgrade in MS-DOS mode.

Setup cannot continue and will now close.
If you restart the computer in MS-DOS mode and try to install Windows 95, you may receive a general protection (GP) fault error message during the detection portion of Setup. If you ignore this error message, Setup continues and finishes correctly.

CAUSE

When you run Setup from within Windows 95, the computer's BIOS prevents Setup from reliably detecting all the installed hardware in the computer.

RESOLUTION

Restart your computer in MS-DOS mode and then run Setup. If you receive a GP fault error message, ignore the error message and continue.

For information about a possible BIOS upgrade to eliminate this problem, please contact IBM.

MORE INFORMATION

This issue has also been reported on Compaq Presario CDS 520 486SX2/66 computers.

Properties

Article ID: 132186 - Last Review: November 15, 2006 - Revision: 1.1
APPLIES TO
  • Microsoft Windows 95
Keywords: 
KB132186
Retired KB Content Disclaimer
This article was written about products for which Microsoft no longer offers support. Therefore, this article is offered "as is" and will no longer be updated.

Give Feedback

 

Contact us for more help

Contact us for more help
Connect with Answer Desk for expert help.
Get more support from smallbusiness.support.microsoft.com