Re-enabling CMD PCI IDE Controller Hangs Computer

If you re-enable a disabled CMD PCI controller in Device Manager and click OK when you are prompted "Do you want to restart your computer now," the computer beeps repeatedly and stops responding (hangs). Or, the computer may restart normally but the CMD PCI controller may remain disabled in Device Manager.

Windows 95 does not support dynamic disabling and re-enabling of PCI IDE controllers.

To re-enable the CMD PCI controller, use either of the following methods:

Method 1

Reinstall Windows 95. To do so, run Setup from the command prompt.

Method 2

1. Restart your computer in Safe Mode. To do so, restart your computer, press the F8 key when you see the "Starting Windows 95" message, and then choose Safe Mode from the Startup menu.
2. In Control Panel, double-click System.
3. On the Device Manager tab, double-click the Hard Disk Controllers branch to expand it.
4. Click the CMD PCI IDE controller, and then click Remove.
5. Once the device is removed, restart Windows 95 normally. The CMD PCI controller should be redetected automatically. After Windows 95 installs the drivers for the controller, restart the computer.