Article ID: 136747 - View products that this article applies to.
This article was previously published under Q136747
This article has been archived. It is offered "as is" and will no longer be updated.
When you are installing Windows 95, you may receive the following error message and your computer may stop responding (hang) when the hardware detection portion of Setup reaches 100 percent complete:
Setup Detection Warning
Setup has found a hardware device on your computer that is not responding. To try this device again, click Continue.
This problem can occur if one of the following network adapters is installed in your computer:
When the hardware detection process is finished, Setup checks to make sure that all critical hardware devices are still functioning properly. If any of these devices do not respond, the error message stated above is displayed. The devices listed above are known to cause the computer to hang when Setup attempts to check their status.
Turn the computer off, wait a few seconds, turn it back on, run Setup again, and choose Safe Recovery when you are prompted.
The process that Setup uses to check the status of devices installed in the computer may cause a device to become unstable. When this occurs, turning the computer off and back on again reinitializes the device.
Article ID: 136747 - Last Review: September 27, 2013 - Revision: 1.1
Contact us for more help
Connect with Answer Desk for expert help.