Buslogic BT-930 Flashpoint LT SCSI Controller Needs OEM Driver

Article translations Article translations
Article ID: 146817 - View products that this article applies to.
This article was previously published under Q146817
This article has been archived. It is offered "as is" and will no longer be updated.
Expand all | Collapse all

SUMMARY

Buslogic Flashpoint LT PCI SCSI controllers require an OEM (Original Equipment Manufacturer) driver to work properly under Windows NT. If you are installing Windows NT on a system that contains the Buslogic Flashpoint LT SCSI controller you must use the OEM driver disk during Windows NT Setup to recognize attached hard disks and CD-ROMs.

NOTE: Only the flashpoint LT controller driver dated 12-07-95 or later works correctly.

If you do not specify the OEM driver you may experience the following STOP message:
STOP 0x0000007B INACCESSIBLE_BOOT_DEVICE

MORE INFORMATION

This driver can be downloaded by contacting Buslogic.

- Buslogic technical support: (408) 970-1414

- Buslogic BBS: (408)492-1984



The Flashpoint LT PCI SCSI controller discussed here is manufactured by and Buslogic, a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding the products' performance or reliability.

The third-party contact information included in this article is provided to help you find the technical support you need. This contact information is subject to change without notice. Microsoft in no way guarantees the accuracy of this third-party contact information.

Properties

Article ID: 146817 - Last Review: February 28, 2014 - Revision: 4.2
APPLIES TO
  • Microsoft Windows NT Workstation 3.5
  • Microsoft Windows NT Workstation 3.51
  • Microsoft Windows NT Server 3.5
  • Microsoft Windows NT Server 3.51
Keywords: 
kbnosurvey kbarchive KB146817

Contact us for more help

Contact us for more help
Connect with Answer Desk for expert help.
Get more support from smallbusiness.support.microsoft.com