Windows 位于根文件夹中的文件的说明

文章翻译 文章翻译
文章编号: 151667 - 查看本文应用于的产品
展开全部 | 关闭全部

概要

本文介绍一些您可能会发现 Windows 文件在硬盘的根目录文件夹。

更多信息

Autoexec.bat-Windows 配置文件
   This file contains commands that should be run by Windows before
   the 32-bit portion of the operating system is started.
				

   This file is necessary only if you need to load a real-mode driver.
				

Autoexec.dos-前一个 MS-DOS Autoexec.bat 文件
   This file contains the original Autoexec.bat file from the previous
   operating system. It is used if you boot the previous operating
   system.
				

Bootlog.prv-以前的 Windows 启动日志文件
   This file records the progress of the previous Windows startup
   process. When you request a logged boot (or if Windows performs one
   automatically), the previous Bootlog.txt file is renamed to Bootlog.prv
   before the new Bootlog.txt file is created.
				

   This file is not necessary for the proper operation of Windows and
   can be deleted.
				

Bootlog.txt-Windows 启动日志文件
   This file records the progress of the Windows startup (boot)
   process. It is created if you request a logged boot, and is also
   created automatically by Windows if Windows detected that the
   previous boot was unsuccessful.
				

   This file is not necessary for the proper operation of Windows and
   can be deleted.
				

Command.com-Windows 命令行处理器
   This program is the Windows command line processor.
				

   This file is necessary for the proper operation of Windows and
   should not be deleted.
				

Command.dos-前一个 MS-DOS Command.com 文件
   This file contains the original Command.com file from the previous
   operating system. It is used if you request to boot the previous
   operating system.
				

Config.dos-前一个 MS-DOS Config.sys 文件
   This file contains the original Config.sys file from the previous
   operating system. It is used if you boot the previous operating
   system.
				

Config.sys-Windows 配置文件
   This file contains parameters that describe the real-mode (16-bit)
   drivers that should be loaded into memory as part of the Windows
   startup process.
				

   This file is necessary only if you need to load a real-mode driver.
				

Cvt.log-驱动器转换器 (FAT32) 日志文件
   This file is created by the Drive Converter (FAT32)
   when you convert a drive to FAT32 and may be useful
   for troubleshooting failed conversions.
				

   To remove this file, delete it from Windows Explorer.
				

Detlog.old-前一个 Windows 检测日志文件
   This file records the progress of the previous Windows hardware
   detection process. When you request that new hardware be detected, the
   previous Detlog.txt file is renamed to Detlog.old before the new
   Detlog.txt file is created.
				

   This file is not necessary for the proper operation of Windows and
   can be deleted.
				

Detlog.txt-Windows 检测日志文件
   This file records the progress of the Windows hardware detection
   process. It is created during hardware detection and is consulted by
   the hardware detection recovery process if the previous attempt to
   detect hardware caused problems.
				

   This file is not necessary for the proper operation of Windows and
   can be deleted.
				

Io.dos-前一个 MS-DOS Io.sys 文件
   This file contains the original Io.sys file from the previous operating
   system. It is used if you boot the previous operating system.
				

Io.sys-MS-DOS 窗口
   This file contains Windows MS-DOS.
				

   This file is necessary for the proper operation of Windows and
   should not be deleted.
				

Logo.sys-Windows 徽标
   This file contains the Windows logo that is displayed as part of the
   startup process.
				

   Note that Windows 98 does not use the Logo.sys file. If you are running
   Windows 98, this file may not exist in the root folder.
				

Msdos.dos-前一个 MS-DOS Msdos.sys 文件
   This file contains the original Msdos.sys file from the previous
   operating system. It is used if you boot the previous operating
   system.
				

Msdos.sys-Windows 配置文件
   This file contains parameters necessary for the early phases of the
   Windows startup process. For more information, please see the
   following article in the Microsoft Knowledge Base:
				

文章 ID: 118579
标题: Windows Msdos.sys 文件内容

   This file is necessary for the proper operation of Windows and
   should not be deleted.
				

Oemlog.txt-Windows 原始设备制造商 (OEM) 日志文件
   This file records the progress of the Windows OEM preinstallation
   process.
				

   This file is not necessary for the proper operation of Windows and
   can be deleted.
				

Scandisk.log-磁盘扫描程序日志文件
   This file is created by the ScanDisk program to record the result of
   the most recent disk scan.
				

   This file is not necessary for the proper operation of Windows and
   can be deleted.
				

Setuplog.txt-Windows 安装程序日志文件
   This file is created by Windows Setup to record the progress of the
   installation procedure. It is consulted by Windows Setup as part of
   installation recovery.
				

   This file is not necessary for the proper operation of Windows and
   can be deleted.
				

Suhdlog.dat-Windows 安装程序的硬盘日志文件
   This file contains a copy of all Master Boot Records and Partition Boot
   Records on the system both before and after the upgrade to Windows.
   This file is used by Windows Uninstall to restore the hard disk
   master boot sector as part of the uninstall process.
				

   To remove this file, click "Old Windows 3.x and MS-DOS system files" in
   the Add/Remove Programs tool and then click Add/Remove.
				

System.1st 的第一个 Windows 的注册表
   This file contains a copy of the original registry created by Windows setup.
				

   Although this file is not necessary for the proper operation of Windows
   and can be deleted, it is recommended that the file be retained
   because it can be used to restore the registry should it become
   damaged.
				

Videorom.bin-一份板载视频卡的 rom。


   This file is used by Windows 98 to support multiple
   monitors. It is created during startup, when the system
   has only one video adapter (if the file does not already
   exist). If you delete this file, you lose support
   for multiple monitors until you remove all but your
   primary video adapter and restart Windows (so that
   this file can be re-created).
				

W95undo.dat-Windows 95 卸载数据文件
   This file contains a compressed backup of Windows 3.x files that were
   replaced as part of the Windows 95 installation process. It is created
   by Windows 95 Setup and is used as part of the Windows 95 uninstall
   process.
				

   To remove this file, click "Old Windows 3.x and MS-DOS system files" in
   the Add/Remove Programs tool and then click Add/Remove.
				

W95undo.ini-Windows 95 卸载脚本文件
   This file contains a listing of files backed up in the W95undo.dat
   file. It is created by Windows 95 Setup and is used as part of the
   Windows 95 uninstall process.
				

   To remove this file, click "Old Windows 3.x and MS-DOS system files" in
   the Add/Remove Programs tool and then click Add/Remove.
				

属性

文章编号: 151667 - 最后修改: 2013年6月8日 - 修订: 2.0
这篇文章中的信息适用于:
  • Microsoft Windows 95
关键字:?
kbinfo kbsetup kbmt KB151667 KbMtzh
机器翻译
重要说明:本文是由 Microsoft 机器翻译软件进行的翻译并可能由 Microsoft 社区通过社区翻译机构(CTF)技术进行后期编辑,或可能是由人工进行的翻译。Microsoft 同时向您提供机器翻译、人工翻译及社区后期编辑的文章,以便对我们知识库中的所有文章以多种语言提供访问。翻译的文章可能存在词汇、句法和/或语法方面的错误。Microsoft 对由于内容的误译或客户对内容的使用所导致的任何不准确、错误或损失不承担责任。
点击这里察看该文章的英文版: 151667
Microsoft和/或其各供应商对于为任何目的而在本服务器上发布的文件及有关图形所含信息的适用性,不作任何声明。 所有该等文件及有关图形均"依样"提供,而不带任何性质的保证。Microsoft和/或其各供应商特此声明,对所有与该等信息有关的保证和条件不负任何责任,该等保证和条件包括关于适销性、符合特定用途、所有权和非侵权的所有默示保证和条件。在任何情况下,在由于使用或运行本服务器上的信息所引起的或与该等使用或运行有关的诉讼中,Microsoft和/或其各供应商就因丧失使用、数据或利润所导致的任何特别的、间接的、衍生性的损害或任何因使用而丧失所导致的之损害、数据或利润不负任何责任。

提供反馈

 

Contact us for more help

Contact us for more help
Connect with Answer Desk for expert help.
Get more support from smallbusiness.support.microsoft.com