Blue Screen on Reboot After Installing Corel CD Creator 2.0

Article translations Article translations
Article ID: 154915 - View products that this article applies to.
This article was previously published under Q154915
This article has been archived. It is offered "as is" and will no longer be updated.
Expand all | Collapse all

Symptoms

When you restart your computer after installing Corel CD Creator version 2.0, you may receive one of the following error messages on a blue screen:
STOP: 0x0000001E (0xC0000005,0x802F2594,0x00000001,0x00000000)
KMODE_EXCEPTION_NOT_HANDLED

STOP: 0x0000000A (0xE1193F88, 0x00000002, 0, 0x8038E019)
IRQL_NOT_LESS_OR_EQUAL - PORTDRVR.SYS
This error may also occur when upgrading to Windows NT 4.0 if the system already has Corel installed.

Cause

The Portdrvr.sys file installed by CD Creator version 2.0 is incompatible with Windows NT version 4.0.

Resolution

To correct this problem, use one of the following methods:
  • Restart your computer and press the SPACEBAR when you see the "Press spacebar NOW to invoke Hardware Profile/Last Known Good menu" message.

    NOTE: The last known good configuration works only if you have not successfully logged on since the problem began. If the error occurred during an upgrade to Windows NT 4.0, then this method will not work and you should use the following method.

    -or-
  • Rename Portdrvr.sys in the %SystemRoot%\System32\Drivers folder.

    NOTE: If Windows NT is installed on a FAT partition, boot to MS-DOS using either a bootable floppy disk or the MS-DOS option on the startup menu. If Windows NT is installed on an NTFS partition, install a parallel copy of Windows NT to access the drive.

    -or-

    In Control Panel, double-click Devices, and then set the Startup option for Port Driver to disabled. Then restart your computer.

    You can also disable the Port Driver device from a parallel installation using the steps from the following Microsoft Knowledge Base article:

    ARTICLE-ID: 165748
    TITLE : How to Disable a Service or Device that Prevents NT from Booting

More information

CD Creator 2.0 is manufactured by Adaptec, a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding this product's performance or reliability.



For additional information about related issues in Windows 2000, click the following article number to view the article in the Microsoft Knowledge Base:
839516 You may receive stop error messages when you try to run Adaptec Easy CD Creator or Adaptec DirectCD on a Windows 2000-based computer

Properties

Article ID: 154915 - Last Review: November 2, 2013 - Revision: 4.0
Applies to
  • Microsoft Windows 2000 Server
  • Microsoft Windows 2000 Advanced Server
  • Microsoft Windows 2000 Professional Edition
  • Microsoft Windows NT Server 4.0 Standard Edition
  • Microsoft Windows NT Workstation 4.0 Developer Edition
Keywords: 
kbnosurvey kbarchive kb3rdparty kbsetup KB154915

Give Feedback

 

Contact us for more help

Contact us for more help
Connect with Answer Desk for expert help.
Get more support from smallbusiness.support.microsoft.com