Article ID: 164474 - Last Review: November 15, 2006 - Revision: 1.1

0E Exception in NWLINK Sending Message from Microsoft Exchange

Retired KB ArticleRetired KB Content Disclaimer
View products that this article applies to.
This article was previously published under Q164474
Expand all | Collapse all

SYMPTOMS

When you try to send a message in Microsoft Exchange or Windows Messaging using SPX over a dialup connection, you may receive the following error message:
An exception 0E has occurred at 0028:c00175e6 in VxD NWLINK(01) + 0000438A. This was called from 0028:c0017014 in VxD NWLINK(01) + 00003db8. It may be possible to continue normally.
This problem occurs only when you start Microsoft Exchange or Windows Messaging offline and then use the Deliver Now command to deliver messages using a dialup connection.
Back to the top

CAUSE

Nwlink.vxd is accepting packets larger than the maximum frame size.
Back to the top

STATUS

This problem no longer occurs in Windows 98. To resolve this problem, install the current version of Windows. For information about the current version of Windows, visit http://www.microsoft.com/windows (http://www.microsoft.com/windows) .
Back to the top

MORE INFORMATION

For information about configuring the maximum IPX packet size, see the following article in the Microsoft Knowledge Base:
166321  (http://support.microsoft.com/kb/166321/EN-US/ ) Configuring Maximum IPX Packet Size in Windows 95
Back to the top
APPLIES TO
  • Microsoft Windows 95
Back to the top
Keywords: 
kberrmsg kbnetwork kbprb KB164474
Back to the top
Retired KB ArticleRetired KB Content Disclaimer
This article was written about products for which Microsoft no longer offers support. Therefore, this article is offered "as is" and will no longer be updated.
Back to the top
 

Get Help Now

Contact a support professional by E-mail, Online, or Phone

Article Translations