STOP 0x00000050 in Srv.sys When Shutting Down Computer

Article translations Article translations
Article ID: 167362 - View products that this article applies to.
This article was previously published under Q167362
This article has been archived. It is offered "as is" and will no longer be updated.
Expand all | Collapse all

Symptoms

After you log on to a computer running Windows NT Server or Workstation and then immediately shutting down the system, you may receive a STOP: 0x00000050 in Srv.sys. The parameters may look like the following:
STOP 0x00000050 (0xf08c5f51, 0x00000000, 0x00000000, 0x00000000).
NOTE: The first parameter will always have the same value, but that value depends on where Srv.sys loads on the system.

Cause

A shutdown handler was registered by Srv.sys, which runs after srv.sys has already been unloaded from the system. Because Srv.sys has been unloaded, you will see a STOP 0x50. This may generally happen on multiprocessor computers with more than two network adapters installed in the system.

Status

Microsoft has confirmed this to be a problem in Windows NT version 4.0. This problem was corrected in the latest Microsoft Windows NT 4.0 U.S. Service Pack. For information on obtaining the service pack, query on the following word in the Microsoft Knowledge Base (without the spaces):
S E R V P A C K

Properties

Article ID: 167362 - Last Review: October 26, 2013 - Revision: 2.0
Applies to
  • Microsoft Windows NT Workstation 4.0 Developer Edition
  • Microsoft Windows NT Server 4.0 Standard Edition
Keywords: 
kbnosurvey kbarchive kbbug KB167362

Give Feedback

 

Contact us for more help

Contact us for more help
Connect with Answer Desk for expert help.
Get more support from smallbusiness.support.microsoft.com