Article ID: 172799 - Last Review: July 15, 2004 - Revision: 3.1

Extra Form Feed Printed With LU3 Print Job

View products that this article applies to.

System TipThis article applies to a different operating system than the one you are using. Article content that may not be relevant to you is disabled.

This article was previously published under Q172799

Expand all | Collapse all

SYMPTOMS

When you print an LU3 host print job through Microsoft SNA Server, an extra form feed occurs after the job is printed.

Back to the top

CAUSE

The host was sending the following characters at the end of the print job:

0C 0D 19    *or*   0C 19

where:

0C = form feed (FF)
0D = carriage return (CR)
19 = end of medium/end of message (EM)

Both FF and EM were resulting in form feeds, causing an extra form feed to occur.

Back to the top

RESOLUTION

To correct this problem, a PDF file can be used which eliminates the form feed sent at the end of the print job. To configure this, follow these steps:

Copy the default <SNARoot>\System\Hplj2.pdf file to Noff.pdf (or whatever name you wish).
Edit the Noff.pdf file and change the END_JOB entry to read as follows: END_JOB = CUL CBP CS1

The default is "END_JOB = CUL CBP CS1 FFF", where FFF = form feed.
Compile the Noff.pdf file as follows: PDFCOMP NOFF.PDF NOFF.PDT
Configure the SNA Print Server session to use the PDT file using SNA Manager. To do this, choose the Print Server session property page, and focus on the Overrides folder. At the bottom of this folder, choose the following:

[X] PDF C:\sna\system\noff.pdt

and click OK.
Save the configuration file, Noff.pdf, then stop and start the SNA Print Server.

Back to the top

Microsoft has confirmed that this is a problem in the Microsoft products that are listed at the beginning of this article.
Microsoft is researching this problem and will post more information in this article when the information becomes available.

Back to the top