Multiple Credentials in a Single Windows NT Session

Article translations Article translations
Article ID: 173199 - View products that this article applies to.
This article was previously published under Q173199
Expand all | Collapse all

SYMPTOMS

Windows NT allows users to connect to multiple resources using multiple user credentials but only allows a single user to use a connection.

If you attempt to connect to the same resource with different credentials, you will get an error message stating that the credentials supplied conflict with an existing set of credentials. If you attempt this operation from an MS-DOS command line, you receive the following error:

System error 1219 has occurred.

CAUSE

Windows NT will attempt to use the same virtual circuit even if a different set of credentials is supplied because the resource name is identical.

RESOLUTION

Provide the TCP/IP address of the computer instead of the computer name.

MORE INFORMATION

It is possible to use multiple user credentials to connect to the same resource on Windows NT when TCP/IP is used as the protocol to establish the connection.

If you connect to the same resource but use the TCP/IP address of the host instead of the computer name, you will be able to connect to the same resource with a different set of credentials.

Example:

net use * \\dabears\utils /U:raydev net use * \\10.100.57.1\utils /U:administrator

Properties

Article ID: 173199 - Last Review: October 31, 2006 - Revision: 1.1
APPLIES TO
  • Microsoft Windows NT Workstation 4.0 Developer Edition
  • Microsoft Windows NT Server 4.0 Standard Edition
Keywords: 
kbprb KB173199

Give Feedback

 

Contact us for more help

Contact us for more help
Connect with Answer Desk for expert help.
Get more support from smallbusiness.support.microsoft.com