This article describes how to make a Windows 98 Startup disk from MS-DOS.
This may be necessary if you cannot start Windows 98 normally, but you can
start your computer to a command prompt and access your hard disk. This
may also be necessary if you have a laptop computer that has a CD-ROM
drive and a floppy disk drive that are interchangeable.
To make a Windows 98 Startup disk from MS-DOS, use the following steps:
- Restart your computer, press and hold down the CTRL key until the
Windows 98 Startup menu appears, and then choose Command Prompt Only
from the Startup menu.
- Insert a blank, formatted floppy disk into drive A.
- Type the following commands, pressing ENTER after each command:
NOTE: Smartdrv.exe is not required to create a Windows 98 Startup disk.
It is used only to speed the creation of the startup disk.
- Follow the instructions on the screen to finish making the Startup
Article ID: 186300 - Last Review: May 7, 2007 - Revision: 1.3
- Microsoft Windows 98 Standard Edition
- Microsoft Windows 98 Second Edition
|kbfaq kbfaq kbhowto KB186300|