Article ID: 187623 - View products that this article applies to.
This article was previously published under Q187623
NoticeThis article applies to Windows 2000. Support for Windows 2000 ends on July 13, 2010. The Windows 2000 End-of-Support Solution Center
(http://support.microsoft.com/?scid=http%3a%2f%2fsupport.microsoft.com%2fwin2000)is a starting point for planning your migration strategy from Windows 2000. For more information see the Microsoft Support Lifecycle Policy
By default Terminal Server and Windows 2000 Terminal Services uses TCP port 3389 for client connections. Microsoft does not recommend that this value be changed. However, if it becomes necessary to change this port, follow these instructions.
Important This section, method, or task contains steps that tell you how to modify the registry. However, serious problems might occur if you modify the registry incorrectly. Therefore, make sure that you follow these steps carefully. For added protection, back up the registry before you modify it. Then, you can restore the registry if a problem occurs. For more information about how to back up and restore the registry, click the following article number to view the article in the Microsoft Knowledge Base:
(http://support.microsoft.com/kb/322756/ )How to back up and restore the registry in Windows
To change the default port for all new connections created on the Terminal Server:
To Alter the Port on the Client Side
(http://support.microsoft.com/kb/326945/ )How to change the listening port in the Windows Terminal Server Web client
NOTE: You must restart the Terminal Server before the new listening port becomes active, or recreate the RDP listener via Terminal Services configuration.
Contact us for more help
Connect with Answer Desk for expert help.