Suwin Error in Setupx.dll During Windows 95/98 Setup

Article ID: 188107 - View products that this article applies to.
This article was previously published under Q188107
If this article does not describe the error message that you are receiving, view the following Microsoft Knowledge Base article to view more articles that describe error messages:
315854
(http://support.microsoft.com/kb/315854/EN-US/ )
Windows 98 and Windows Me Error Message Resource Center
Expand all | Collapse all

SYMPTOMS

When you attempt to upgrade Microsoft Windows 3.1 to Windows 95/98, you may receive the following error message:
SUWIN
An error has occurred in your application. If you choose ignore you should save your work in a new file. If you choose close, your application will terminate."

When you click Close, you may receive the following error message:
Application Error
SUWIN caused a general protection fault in module setupx.dll @ 0012:1346
Back to the top | Give Feedback

CAUSE

This behavior can occur if you disable virtual memory in Windows 3.1 before you run Windows 95/98 Setup.
Back to the top | Give Feedback

RESOLUTION

To resolve this issue, enable virtual memory in Windows 3.1 before running Windows 95/98 Setup, or quit Windows to MS-DOS, and then run Setup from MS-DOS. To enable virtual memory in Windows 3.1 before running Windows 95/98 Setup, follow these steps:
  1. In the Main group, open Control Panel and double-click 386 Enhanced.
  2. Click Virtual Memory, and then click Change.
  3. In the Type box, click Permanent or Temporary, and then click OK.
Back to the top | Give Feedback

Properties

Article ID: 188107 - Last Review: January 23, 2007 - Revision: 1.2
APPLIES TO
  • Microsoft Windows 98 Standard Edition
  • Microsoft Windows 95
Keywords: 
kberrmsg kbgpf kbprb kbsetup KB188107
Back to the top | Give Feedback

Give Feedback

 
Back to the topBack to the top