General Protection Fault Error Message Opening Control Panel

Article translations Article translations
Article ID: 193882 - View products that this article applies to.
This article was previously published under Q193882
This article has been archived. It is offered "as is" and will no longer be updated.
If this article does not describe the error message that you are receiving, view the following Microsoft Knowledge Base article to view more articles that describe error messages:
315854 Windows 98 and Windows Me Error Message Resource Center
Expand all | Collapse all

Symptoms

When you open Control Panel, you may receive the either of the following error messages:
EXPLORER caused a general protection fault in module qtw16.cpl at <address>
-OR-
EXPLORER caused a general protection fault in module qtw32.cpl at <address>
After you receive one of these error messages, your computer may stop responding (hang). This may also occur in Safe mode.

Cause

This behavior can occur if one or more Apple QuickTime for Windows files are missing or damaged.

Resolution

To resolve this behavior, remove QuickTime for Windows. To do so, follow these steps:

  1. Restart the computer. For Windows 95, when you see the "Starting Windows 95" message, press the F8 key, and then choose Safe Mode Command Prompt Only from the Startup menu.

    For Windows 98, Windows 98 SE, or Windows Me, press and hold down the CTRL key after your computer completes the Power On Self Test (POST), and then choose Safe Mode Command Prompt Only from the Startup menu. For more information about Windows 98 startup, see the following article in the Microsoft Knowledge Base:
    ARTICLE-ID: 178548
    TITLE : No "Starting Windows 98" Message at Startup
  2. At the command prompt, type the following commands, pressing ENTER after each command:
    cd\windows\system
    ren qtw16.cpl qtw16.xxx
    ren qtw32.cpl qtw32.xxx
  3. Restart your computer normally.
  4. Click Start, point to Settings, click Control Panel, and then double-click Add/Remove Programs.
  5. On the Install/Uninstall tab, click QuickTime For Windows, and then click Add/Remove.
NOTE: To view QuickTime files, you must reinstall QuickTime for Windows. For information about how to do so, contact Apple Technical Support.

More information

QuickTime is manufactured by Apple Computer Corporation, a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding this product's performance or reliability.

For more information about hardware and software vendor contact information, visit the following Microsoft Web site: -
  http://support.microsoft.com/gp/vendors  

Note This is a "FAST PUBLISH" article created directly from within the Microsoft support organization. The information contained herein is provided as-is in response to emerging issues. As a result of the speed in making it available, the materials may include typographical errors and may be revised at any time without notice. See Terms of Use for other considerations.

Properties

Article ID: 193882 - Last Review: October 25, 2013 - Revision: 1.0
Applies to
  • Microsoft Windows 95
Keywords: 
kbnosurvey kbarchive kb3rdparty kberrmsg kbgpf kbprb KB193882

Give Feedback

 

Contact us for more help

Contact us for more help
Connect with Answer Desk for expert help.
Get more support from smallbusiness.support.microsoft.com