OL2000: (CW) Connect Error Using SPRYNET Internet Mail

Article ID: 197228 - View products that this article applies to.
This article was previously published under Q197228


NOTE: These procedures only apply if you have installed Outlook with the Corporate Workgroup/Other option. This option allows you to use Messaging Application Programming Interface (MAPI) services. To determine your installation type, on the Help Menu click About Microsoft Outlook. In About Microsoft Outlook you should see "Corporate" if you have the Corporate Workgroup installation.
Expand all | Collapse all

On This Page

SYMPTOMS

When you start Microsoft Outlook or initially connect to your SPRYNET Internet Mail server, you may receive the following error message:
You could not be logged on to mail server: <servername>. Be sure your account information is accurate. If this problem persists, contact your Internet Service Provider.
Following this message, you may notice that sent mail does not leave your Outbox.
Back to the top | Give Feedback

CAUSE

This problem may be caused by incorrect settings in the Internet E-Mail Service properties.
Back to the top | Give Feedback

MORE INFORMATION

Incorrect Settings Using the Internet E-Mail Service

To troubleshoot this problem, follow these steps:

  1. Click Start, point to Settings, and click Control Panel.
  2. Double-click the Mail And Fax icon. You may only have a Mail icon if you did not install Fax services.
  3. If you have more than one profile, click Show Profiles and on the General tab, click the profile that contains your SPRYNET Internet Mail settings.
  4. Click Properties and on the Services tab, you should see the Internet Mail service. If not, click Add to add the Internet Mail service.
  5. On the Services tab, click Internet Mail, and then click Properties.
  6. Click the Servers tab and in the Outgoing Mail (SMTP) box and in lowercase, type:
    m1.sprynet.com
  7. In the Incoming Mail (POP3) box in lowercase, type:
    m1.sprynet.com
    NOTE: If your mail server information is different than listed here, use the server names provided by SPRYNET.
  8. In Account Name, type your e-mail name, and in Password, type your password. The e-mail password is all lowercase letters with a number in the middle (example: dogs2cats).
  9. Click OK, OK, and Close to close all dialog boxes.
Start Outlook and try to send a message.

SPRYNET's Internet Mail system currently uses one server for both receipt and sending of messages. If no server is specified in the Advanced Options of the original Internet Mail service profile, the Internet Mail server box will identify both the mail server from which you receive mail (incoming) and the mail server from which you send mail (outgoing).

The server name must be typed into both the Incoming Mail (POP3) and the Outgoing Mail (SMTP) boxes.
Back to the top | Give Feedback

REFERENCES

To obtain your personal SPRYNET e-mail account information contact SPRYNET Technical Support at the following telephone number: 

   (800)557-9614


Sprynet Technical support is also available at the following Web site:
http://www.sprynet.com/members/techs/
(http://www.sprynet.com/members/techs/)
The third-party contact information included in this article is provided to help you find the technical support you need. This contact information is subject to change without notice. Microsoft in no way guarantees the accuracy of this third-party contact information.

The third-party products discussed here are manufactured by vendors independent of Microsoft; we make no warranty, implied or otherwise, regarding these products' performance or reliability.
Back to the top | Give Feedback

Properties

Article ID: 197228 - Last Review: October 9, 2003 - Revision: 3.0
APPLIES TO
  • Microsoft Outlook 2000 Standard Edition
Keywords: 
kberrmsg kbprb kb3rdparty KB197228
Back to the top | Give Feedback

Give Feedback

 
Back to the topBack to the top