Article ID: 216684 - View products that this article applies to.
This article was previously published under Q216684
When you use the System Preparation tool (Sysprep) on a computer running Windows NT, you may receive the following error message after rebooting:
The system is not fully installed.
Please run setup again.
The registry setting that Sysprep uses to mark its progress is incorrectly set when some third-party network clients are installed on the computer.
To resolve this problem, obtain the latest service pack for Windows NT 4.0 or the individual software update. For information on obtaining the latest service pack, please go to:
Important This section, method, or task contains steps that tell you how to modify the registry. However, serious problems might occur if you modify the registry incorrectly. Therefore, make sure that you follow these steps carefully. For added protection, back up the registry before you modify it. Then, you can restore the registry if a problem occurs. For more information about how to back up and restore the registry, click the following article number to view the article in the Microsoft Knowledge Base:
(http://support.microsoft.com/kb/322756/ )How to back up and restore the registry in Windows
NOTE: The following steps are to be used with the non-hotfixed version of Sysprep.exe only.
To prevent this issue from occurring, remove the third-party network client from the computer before making the image or running Sysprep.
To work around this issue, install a parallel installation of Windows NT 4.0 in a different partition and then use Registry Editor to change the data value of the SystemSetupInProgress value from 1 to 0:
Contact us for more help
Connect with Answer Desk for expert help.