DHCP Scope Marked "Bad" After Windows NT Service Pack 3 Installation

Article translations Article translations
Article ID: 219314 - View products that this article applies to.
This article was previously published under Q219314
This article has been archived. It is offered "as is" and will no longer be updated.
Expand all | Collapse all

SYMPTOMS

After you install Windows NT Server 4.0 Service Pack 3 on a Windows NT-based computer that has the Dynamic Host Control Protocol (DHCP) service installed, TCP/IP addresses in one or more DHCP scopes may be displayed as "BAD". Entire scopes may be displayed this way when an internetworking device (such as a router), is not functioning properly, or the DHCP service receives an Internet Control Message Protocol (ICMP) packet coded with the destination unreachable flag.

RESOLUTION

To resolve this problem, obtain the latest service pack for Windows NT 4.0. For additional information, click the following article number to view the article in the Microsoft Knowledge Base:
152734 How to Obtain the Latest Windows NT 4.0 Service Pack

STATUS

Microsoft has confirmed that this is a problem in Windows NT Server version 4.0 Service Packs 3 and 4. This problem was first corrected in Windows NT version 4.0 Service Pack 5.

Properties

Article ID: 219314 - Last Review: October 14, 2013 - Revision: 1.2
APPLIES TO
  • Microsoft Windows NT 4.0 Service Pack 3
  • Microsoft Windows NT 4.0 Service Pack 4
Keywords: 
kbnosurvey kbarchive kbhotfixserver kbqfe kbbug kbfix kbnetwork kbqfe KB219314

Give Feedback

 

Contact us for more help

Contact us for more help
Connect with Answer Desk for expert help.
Get more support from smallbusiness.support.microsoft.com