FIX: Visual InterDev Error When Switching to Source View with DTCs

Article ID: 224936 - View products that this article applies to.
This article was previously published under Q224936
Expand all | Collapse all

On This Page

SYMPTOMS

Visual InterDev 6.0 fails with a General Protection Fault (GPF), when switching from Design View to Source View if a Page Transition (Design-Time Controls) DTC and Recordset DTC have been added to an Active Server Pages (ASP) page.
Back to the top | Give Feedback

STATUS

Microsoft has confirmed that this is a bug in the Microsoft products that are listed at the beginning of this article.

This bug was corrected in Visual Studio 6.0 Service Pack 3. For more information about Visual Studio service packs, please see the following articles in the Microsoft Knowledge Base:
194022
(http://support.microsoft.com/kb/194022/EN-US/ )
INFO: Visual Studio 6.0 Service Packs, What, Where, Why

194295
(http://support.microsoft.com/kb/194295/EN-US/ )
HOWTO: Tell That Visual Studio 6.0 Service Packs Are Installed
Back to the top | Give Feedback

MORE INFORMATION

Steps to Reproduce Behavior

  1. Open an ASP page.
  2. Add a Page Transition DTC within the <head></head> tags.
  3. Switch to Design View.
  4. Add a Recordset DTC to the page.
  5. Answer Yes to the enable SOM prompt.
  6. Switch back to Source View.

Result: Visual InterDev will cause a General Protection Fault and shut down.
Back to the top | Give Feedback

Properties

Article ID: 224936 - Last Review: October 15, 2002 - Revision: 1.1
APPLIES TO
  • Microsoft Visual InterDev 6.0 Standard Edition
Keywords: 
kbbug kbctrl kbfix kbide kbvs600sp1fix kbvs600sp2fix kbvs600sp3fix KB224936
Back to the top | Give Feedback

Give Feedback

 
Back to the topBack to the top