Default Connection Security Changes Are Not Applied

View products that this article applies to.

This article was previously published under Q225038

Expand all | Collapse all

SYMPTOMS

When you change the default connection settings in the server settings in the Terminal Services Configuration snap-in, the changes are not applied to existing connections.

Back to the top

CAUSE

If you manually edit the permissions on a connection before using one of the default connection settings, the default connection settings are not applied to the connection.

Back to the top

RESOLUTION

To work around this behavior, use either of the following methods:

Delete any existing connections and re-create them. After the connections are re-created, the default connection settings are applied correctly. However, if you manually edit the permissions on a connection, the default connection settings are no longer applied.

Manually assign permissions based on the values of the default connection settings. The default settings are:

Setting                        Permissions
-----------------------------------------------------------------------
Remote Administration Access   System: Full Control; Administrators: 
                               Full Control
Application Server             System: Full Control; Administrators: 
                               Full Control; Users: User Access
Anonymous Access               Everyone: Guest Access; System: Full 
                               Control; Administrators: Full Control; 
                               Users: User Access; Guests: Guest Access

Back to the top