802.1Q VLAN Tagging on NLB enabled adapters

Article translations Article translations
Close Close
Article ID: 2286940 - View products that this article applies to.
Expand all | Collapse all

SUMMARY

Several network adapter manufacturers provide drivers and software which offer the feature to configure IEEE 802.1Q VLAN Tagging on network interfaces. VLAN Tagging allows multiple logical networks to share the same physical network, at which the logical networks are isolated of each other. Network Load Balancing (NLB) and 802.1Q VLAN tagging can be configured on the same adapter.

MORE INFORMATION

NLB in multicast mode fully supports VLAN Tagging.

NLB in unicast mode only supports VLAN Tagging if the virtual network adapter supports dynamic media access control (MAC) address updates. To verify if your network adapter supports dynamic MAC address updates, please consult the network adapter vendor.

In unicast mode, NLB uses a shared virtual MAC address. The shared virtual MAC address is used instead of the physical adapter's MAC address for all communications to the load-balanced IP addresses (VIP). If NLB is not able to overwrite the MAC address of the virtual adapter provided by the network card manufacturer's driver, NLB will be unable to function properly.

Note Support for the VLAN Tagging technology, which includes the hardware as well as the driver which provides the virtual adapters and the configuration software for VLAN Tagging is the responsibility of the network adapter manufacturer. If problems that occur seem to be related to VLAN Tagging, Microsoft Support may request that you disable VLAN tagging while the problem is investigated.

For additional information related to NLB and virtual adapters see:

278431 Using teaming adapters with network load balancing may cause network problems
http://support.microsoft.com/default.aspx?scid=kb;EN-US;278431

For more information on 802.1Q please refer to the IEEE standards
http://standards.ieee.org/getieee802/802.1.html

Note This is a "FAST PUBLISH" article created directly from within the Microsoft support organization. The information contained herein is provided as-is in response to emerging issues. As a result of the speed in making it available, the materials may include typographical errors and may be revised at any time without notice. See Terms of Use for other considerations.

Properties

Article ID: 2286940 - Last Review: September 2, 2010 - Revision: 4.0
APPLIES TO
  • Windows Server 2008 R2 Standard
  • Windows Server 2008 R2 Standard without Hyper-V
  • Windows Server 2008 R2 Enterprise
  • Windows Server 2008 R2 Enterprise without Hyper-V
  • Windows Server 2008 R2 Datacenter
  • Windows Server 2008 R2 Datacenter without Hyper-V
Keywords: 
KB2286940

Give Feedback

 

Contact us for more help

Contact us for more help
Connect with Answer Desk for expert help.
Get more support from smallbusiness.support.microsoft.com