Article ID: 229399 - View products that this article applies to.
This article was previously published under Q229399
When you try to use the NetWare map command to connect to a folder on a NetWare volume from a computer that is running either Client Services for NetWare (CSNW) or Gateway Services for NetWare (GSNW), the operation does not work.
To resolve this behavior, use the net use command on computers that are running CSNW or GSNW to assign drive letters to folders on a NetWare volume.
You can use the following syntax to assign drive letter H to the SYS:Login folder on a NetWare server named NWSERVER1:
net use h: \\nwserver1\sys\login
Microsoft has confirmed that this is a problem in the Microsoft products that are listed at the beginning of this article.
The purpose of the NetWare map command is to assign a drive letter to a folder (Map.exe is located in the NetWare SYS:Public folder). For example, to assign network drive letter H to the SYS:Login folder on the NetWare server named "NWSERVER1," use the following syntax:
map h:=nwserver1/sys:loginRunning this command assigns drive letter H to the folder, so that typing "h:" at a command prompt and then pressing ENTER connects you to the SYS:Login folder on the NetWare server named NWSERVER1.
However, after you run this command from a computer that is running CSNW or GSNW, typing "h:" and then pressing ENTER connects you to the root of the SYS: volume on the NetWare server named NWSERVER1.
Article ID: 229399 - Last Review: February 27, 2007 - Revision: 3.2
Contact us for more help