Article ID: 240251 - View products that this article applies to.
This article was previously published under Q240251
When you turn on your computer and then boot from a floppy disk or hard drive with CD-ROM Support enabled to a command prompt, the following error message is displayed when you try to start Setup.exe from the Windows 2000 CD-ROM:
This program cannot be run in DOS mode.
This behavior occurs because Setup.exe on the Windows 2000 CD ROM is a Windows-based program and cannot be run from an MS-DOS command prompt.
To work around this behavior, boot into an existing Windows installation and re-run Setup. If there are no Windows-based installations on the drive, Microsoft recommends that you start the Windows 2000 installation by booting to the CD-ROM, or use the floppy disks created by the Makeboot.exe program. For more information on how to creat the Setup boot disks, please click the article number below to view the article in the Microsoft Knowledge Base:
197063As an alternative to the above, you can change to the i386 folder on the Windows 2000 CD, and then type:
(http://support.microsoft.com/kb/197063/EN-US/ )How to Create Setup Boot Disks for Windows 2000
Setup.exe is the program that is invoked by the autorun.inf program on the Windows 2000 CD-ROM. This program generates the initial Windows 2000 Startup screen that provides the option to Install Windows 2000, Install Add-On Components, Browse this CD, or Exit.
Contact us for more help
Connect with Answer Desk for expert help.