Some Cluster Disks Are Not Available After Installing SP6

Article translations Article translations
Article ID: 251007 - View products that this article applies to.
This article was previously published under Q251007
This article has been archived. It is offered "as is" and will no longer be updated.
Expand all | Collapse all


After you apply Microsoft Windows NT 4.0 Service Pack 6 (SP6), some cluster disks may not come online. If the quorum disk is affected, the entire cluster does not start. The problem is most likely to occur after you "cold boot" the computer. If cluster logging is enabled, you may see an entry similar to the following example:
Physical Disk Disk X: : SCSI, error reserving disk, error 21.


The partition table on the disk contains an invalid entry that is misinterpreted by the cluster disk driver.


Microsoft has confirmed that this is a problem in the Microsoft products that are listed at the beginning of this article.

To resolve this problem, apply the fix described in the following article:
272569 System Process Loses Delayed-Write Data with Windows Clustering


Article ID: 251007 - Last Review: October 20, 2013 - Revision: 2.2
  • Microsoft Windows NT Server 4.0 Enterprise Edition
  • Microsoft Windows NT 4.0 Service Pack 6a
kbnosurvey kbarchive kbhotfixserver kbqfe kbbug kberrmsg kbfix KB251007

Contact us for more help

Contact us for more help
Connect with Answer Desk for expert help.
Get more support from