Article ID: 253975 - View products that this article applies to.
This article was previously published under Q253975
This article has been archived. It is offered "as is" and will no longer be updated.
Your Iomega Jaz drive may not start but is detected on any computer to which it is attached using the Jaz Traveler, if the Jaz drive's SCSI ID is set to 0-4 or 7. If the Jaz drive is set to SCSI ID 5 or 6, the drive functions correctly.
This behavior occurs if additional code is used during testing of additional devices and is not removed.
To resolve this problem, obtain the latest service pack for Windows 2000. For additional information, click the following article number to view the article in the Microsoft Knowledge Base:
260910The Windows 2000 Update, "Iomega Tools Do Not Recognize Parallel Port Drives," is available on the following Microsoft Web site:
(http://support.microsoft.com/kb/260910/EN-US/ )How to Obtain the Latest Windows 2000 Service Pack
http://update.microsoft.com/NOTE: To view the version, right-click the file in Windows Explorer, click Properties, and then click Version.
Microsoft has confirmed that this is a problem in Microsoft Windows 2000. This problem was first corrected in Windows 2000 Service Pack 1.
For additional information about how to install Windows 2000 and Windows 2000 hotfixes at the same time, click the article number below to view the article in the Microsoft Knowledge Base:
249149The third-party products that are discussed in this article are manufactured by companies that are independent of Microsoft. Microsoft makes no warranty, implied or otherwise, regarding the performance or reliability of these products.
(http://support.microsoft.com/kb/249149/EN-US/ )Installing Microsoft Windows 2000 and Windows 2000 Hotfixes
Article ID: 253975 - Last Review: October 26, 2013 - Revision: 4.0
Contact us for more help
Connect with Answer Desk for expert help.