Article ID: 254611 - Last Review: February 20, 2007 - Revision: 3.4

Eject Request May Cause "Stop 0xA" Error Message

View products that this article applies to.

System TipThis article applies to a different operating system than the one you are using. Article content that may not be relevant to you is disabled.

This article was previously published under Q254611

Expand all | Collapse all

SYMPTOMS

When you request that a device be ejected using the Add/Remove Hardware tool in Control Panel, you may receive a "Stop 0xA" error message.

Back to the top

RESOLUTION

To resolve this problem, obtain the latest service pack for Windows 2000. For additional information, click the following article number to view the article in the Microsoft Knowledge Base:

260910 (http://support.microsoft.com/kb/260910/EN-US/ ) How to Obtain the Latest Windows 2000 Service Pack

Back to the top

STATUS

Microsoft has confirmed that this is a problem in the Microsoft products that are listed at the beginning of this article.

This problem was first corrected in Windows 2000 Service Pack 1.

Back to the top

MORE INFORMATION

For additional information about how to install Windows 2000 and Windows 2000 hotfixes at the same time, click the article number below to view the article in the Microsoft Knowledge Base:

249149 (http://support.microsoft.com/kb/249149/EN-US/ ) Installing Microsoft Windows 2000 and Windows 2000 Hotfixes

Back to the top