Article ID: 256884 - Last Review: October 27, 2006 - Revision: 1.3

TCP and UDP ports that are used by Remote Control have changed in SMS 2.0 Service Pack 2

View products that this article applies to.
System TipThis article applies to a different operating system than the one you are using. Article content that may not be relevant to you is disabled.
This article was previously published under Q256884
Expand all | Collapse all

SUMMARY

The ports utilized by Remote Control have changed in Systems Management Server (SMS) 2.0 Service Pack 2 (SP2).

MORE INFORMATION

Systems Management Server 2.0 Service Pack 2 Remote Tools utilize the following:

Collapse this tableExpand this table
ProcessPortProtocolFeature
sms-rcinfo2701TCPRCINFO
sms-rcinfo2701UDPRCINFO
sms-remctrl2702TCPRemote Control
sms-remctrl2702UDPRemote Control
sms-chat2703TCPChat
sms-chat2703UDPChat
sms-xfer2704TCPFile Transfer
sms-xfer2704UDPFile Transfer


The remote tools have the following functions:
Collapse this tableExpand this table
PortFunction
2701Used for session setup and verify
2702Used for actual remote control
2703Used for remote chat
2704Used for remote file transfer


Before SMS 2.0 SP2, ports used for remote tools were the same in both SMS 2.0 and SMServer 1.2.

For additional information about network ports used by remote helpdesk functions, click the article number below to view the article in the Microsoft Knowledge Base:
167128  (http://support.microsoft.com/kb/167128/EN-US/ ) Network Ports Used by Remote Helpdesk Functions
APPLIES TO
  • Microsoft Systems Management Server 2.0 Service Pack 2
Back to the top
Keywords: 
kbbug kbinfo kbnofix kbsms200presp3 KB256884