Article ID: 257426 - Last Review: February 22, 2007 - Revision: 1.5

XCON: Configuring Exchange 2000 to Use a Smart Host IP Address

View products that this article applies to.
System TipThis article applies to a different operating system than the one you are using. Article content that may not be relevant to you is disabled.
This article was previously published under Q257426
Expand all | Collapse all

SUMMARY

This article provides information on configuring Exchange 2000 to use a smart host IP address.

MORE INFORMATION

You can configure Microsoft Exchange 2000 Server to route mail for remote domains through a smart host. You can identify smart hosts by either a Fully Qualified Domain Name (FQDN) or an IP address. If you use an IP address, you must enclose it in brackets ([]). Exchange 2000 checks first for a server name, and then an IP address. The brackets identify the value as an IP address, so Exchange 2000 bypasses the Domain Name Server (DNS) lookup.

You can specify multiple smart hosts based on either FQDN or IP address separated by a semicolon (;). If you specify a combination of IP address and FQDN, then make sure that the smart hosts specified by IP address appear after those specified by FQDN.

For Example:
ip of smarthost1; ip of smarthost2
fqdn of smarthost1; fqdn of smarthost2
fqdn of smarthost1; ip of smarthost2
The following combination does not load balance:
ip of smarthost1; fqdn of smarthost2
The smart host setting for SMTP virtual servers is similar to the setting configured on the SMTP connectors in Exchange 2000. Microsoft recommends configuring smart hosts on the connector, because connectors can handle message delivery on a per-domain basis.
APPLIES TO
  • Microsoft Exchange 2000 Server Standard Edition
Back to the top
Keywords: 
kbinfo KB257426