Article ID: 259711 - View products that this article applies to.
This article was previously published under Q259711
This article has been archived. It is offered "as is" and will no longer be updated.
When you remove a Plug and Play Universal Serial Bus (USB) hub (a surprise removal) and an application does not close the handle to a device connected to the hub, the application may not open the handle to the device when you plug in the USB hub again.
This behavior occurs because the USB driver does not correctly handle the surprise removal of Plug and Play USB devices.
To resolve this problem, obtain the latest service pack for Windows 2000. For additional information, click the following article number to view the article in the Microsoft Knowledge Base:
(http://support.microsoft.com/kb/260910/EN-US/ )How to Obtain the Latest Windows 2000 Service Pack
To work around this issue, close the device handle when the application receives a "Device Removal" notification message.
Microsoft has confirmed that this is a problem in Microsoft Windows 2000.
This problem was first corrected in Windows 2000 Service Pack 1.
For additional information about how to install Windows 2000 and Windows 2000 hotfixes at the same time, click the article number below to view the article in the Microsoft Knowledge Base:
(http://support.microsoft.com/kb/249149/EN-US/ )Installing Microsoft Windows 2000 and Windows 2000 Hotfixes
Article ID: 259711 - Last Review: October 26, 2013 - Revision: 4.0
Contact us for more help
Connect with Answer Desk for expert help.