Article ID: 262448 - Last Review: March 1, 2007 - Revision: 5.2

Disk Error 11 and ATAPI Error 5 Using DMA Transfer Mode for ATA66 Hard Disk

View products that this article applies to.
This article was previously published under Q262448
Expand all | Collapse all

SYMPTOMS

If you are using DMA transfer mode with an ATA66 hard disk, you may receive the following error messages at startup:
Disk error
Driver detected a controller error on the device, \Device\Harddisk1\DR1

ATAPI Error
Parity error on device \IDE\IDEport1
Back to the top

CAUSE

ATA66 DMA transfer mode is not supported for the onboard IDE controller.
Back to the top

RESOLUTION

To resolve this issue, change the transfer mode for the controller:
  1. Right-click My Computer, and then click Manage.
  2. Double-click System Tools in the right pane, and then double-click Device Manager.
  3. Double-click IDE ATA/ATAPI Controller in the right pane, and then double-click the appropriate controller.
  4. On the Advanced Settings tab, click PIO Only in the Transfer Mode box.
  5. Click OK, close the Computer Management window, and then reboot the computer.
Back to the top

MORE INFORMATION

For a list of compatible IDE controllers, check the Hardware Compatibility List (HCL) at the following Microsoft Web site:
http://www.microsoft.com/whdc/hcl/default.mspx (http://www.microsoft.com/whdc/hcl/default.mspx)
For more information, click the following article number to view the article in the Microsoft Knowledge Base:
154690  (http://support.microsoft.com/kb/154690/ ) How to troubleshoot event ID 9, event ID 11, and event ID 15 error messages
Back to the top
APPLIES TO
  • Microsoft Windows 2000 Server
  • Microsoft Windows 2000 Advanced Server
  • Microsoft Windows 2000 Professional Edition
Back to the top
Keywords: 
kberrmsg kbhardware kbprb KB262448
Back to the top
 

Article Translations