Visio2000: Rotation Command Does Not Work on Door Shape

Retired KB Content Disclaimer

View products that this article applies to.

This article was previously published under Q264411

SYMPTOMS

In Visio 2000 Technical Edition, when you try to rotate a door shape, the door may not rotate as expected.

Back to the top

CAUSE

The rotate feature was changed in Visio 2000 Technical Edition to "flip" the doors rather than to rotate the doors. The rotate feature has been re-implemented in Visio 2000 SR-1.

Back to the top

To add the re-implemented feature to Visio 2000 Technical Edition, obtain Microsoft Visio Service Release 1.

To obtain SR-1, click the article number below to view the article in the Microsoft Knowledge Base:

263721 (http://support.microsoft.com/kb/263721/EN-US/ ) Visio: How to Obtain Microsoft Visio 2000 Service Release 1 (SR-1)

To rotate doors in Visio 2000 Technical Edition:

Right-click the door that you want to rotate, and then click the way that you want to "flip" the door. You can change the door to open in, instead of out, or right, instead of left

Back to the top

STATUS

Microsoft has confirmed this to be a problem in the Microsoft products listed at the beginning of this article. This problem was corrected in Microsoft Visio 2000 SR-1.

Back to the top

MORE INFORMATION

Steps to Reproduce the Behavior

Start Visio.
Open the Office Layout Stencil.
Drag a door onto the page.
On the Standard toolbar, click Rotation Tool.
Try to rotate the door by dragging the green circle.

Note that the door does not move.

Back to the top

APPLIES TO

Microsoft Visio 2000 Technical Edition

Back to the top

KB264411

Back to the top

Retired KB Content Disclaimer

This article was written about products for which Microsoft no longer offers support. Therefore, this article is offered "as is" and will no longer be updated.

Back to the top