Article ID: 266745 - View products that this article applies to.
This article was previously published under Q266745
NoticeThis article applies to Windows 2000. Support for Windows 2000 ends on July 13, 2010. The Windows 2000 End-of-Support Solution Center
(http://support.microsoft.com/?scid=http%3a%2f%2fsupport.microsoft.com%2fwin2000)is a starting point for planning your migration strategy from Windows 2000. For more information see the Microsoft Support Lifecycle Policy
When you attempt to run the fixmbr command in the Microsoft Windows 2000 recovery console, your computer system may display the following error message:
This computer appears to have a non-standard or invalid master boot record. FIXMBR may damage your partition tables if you proceed. This could cause all the partitions on the current hard disk to become inaccessible. If you are not having problems accessing your drive, do not continue. Are you sure you want to write a new MBR?
Ignore the error message described in the "Symptoms" section of this article. The fixmbr command can safely rewrite the MBR.
Microsoft has confirmed that this is a problem in the Microsoft products that are listed at the beginning of this article.
The fixmbr command causes this error message to be displayed on your computer system whenever you run the command, regardless of the state of the Master Boot Record (MBR).
After you run the fixmbr command, your computer reports whether or not the command worked properly. If the command worked, your computer system displays the following message:
Writing new master boot record on physical drive
The new master boot record has been successfully written.
Contact us for more help
Connect with Answer Desk for expert help.