Visio2000 cannot work correctly after you right-click a Multi State shape in Visio 2000 Standard Edition

Retired KB Content Disclaimer

View products that this article applies to.

This article was previously published under Q267250

SYMPTOMS

When you right-click a Multi State shape in a Dataflow Diagram and then click the Stop State command, nothing happens.

Back to the top

RESOLUTION

To resolve this problem, obtain Microsoft Visio 2000 Service Release 1 (SR-1).

To obtain SR-1, click the article number below to view the article in the Microsoft Knowledge Base:

263721 (http://support.microsoft.com/kb/263721/ ) Overview of the Visio 2000 Service Release 1 (SR-1) Update

To temporarily work around this problem, use a Stop State shape instead of a Multi State shape.

Back to the top

STATUS

Microsoft has confirmed that this is a problem in the Microsoft products that are listed at the beginning of this article. This problem was corrected in Microsoft Visio 2000 SR-1.

Back to the top

MORE INFORMATION

Steps to Reproduce the Behavior

On the File menu, point to New, point to Flowchart, and then click Data Flow Diagram.
Drag a Multi State shape onto the page.
Right-click the shape, and then click Stop State.

Note that nothing happens.

Back to the top

APPLIES TO

Microsoft Visio 2000 Standard Edition

Back to the top

kbprb kbtshoot KB267250

Back to the top

Retired KB Content Disclaimer

This article was written about products for which Microsoft no longer offers support. Therefore, this article is offered "as is" and will no longer be updated.

Back to the top