Hewlett-Packard OmniBook Hangs When You Remove 16-bit PC Card After Hibernation or Standby

Article translations Article translations
Article ID: 267747 - View products that this article applies to.
This article was previously published under Q267747
This article has been archived. It is offered "as is" and will no longer be updated.
If this article does not describe the error message that you are receiving, view the following Microsoft Knowledge Base article to view more articles that describe error messages:
315854 Windows 98 and Windows Me Error Message Resource Center
Expand all | Collapse all

SYMPTOMS

When you add a 16-bit (R2) PC Card to a Hewlett-Packard (HP) OmniBook portable computer, and then remove the card after having the computer in Hibernation or Standby mode, the computer may stop responding (hang) and you may receive the following error message:
CMDNINST caused a general protection fault in module KRNL386.EXE at 001:00002867

RESOLUTION

To work around this issue, remove the PC Card before the computer goes into Hibernate or Standby mode, or wait for 10 minutes or so for the computer to fully restore and load drivers.

MORE INFORMATION

The third-party products that are discussed in this article are manufactured by companies that are independent of Microsoft. Microsoft makes no warranty, implied or otherwise, regarding the performance or reliability of these products.


Properties

Article ID: 267747 - Last Review: October 20, 2013 - Revision: 1.2
APPLIES TO
  • Microsoft Windows Millennium Edition
Keywords: 
kbnosurvey kbarchive kbgpf kbhardware kbprb KB267747

Contact us for more help

Contact us for more help
Connect with Answer Desk for expert help.
Get more support from smallbusiness.support.microsoft.com