Article ID: 2699725 - View products that this article applies to.
Outlook has a feature, nicknamed the "sniffer", that automatically processes certain types of messages that are sent to you. For example, if you send an e-mail message with voting buttons and a recipient of that message responds with their vote, their response is processed after it arrives in your Inbox. After this processing occurs, the vote tally is updated in the original message in your Sent Items folder. This automatic processing is done by the sniffer process.
In Outlook versions earlier than Outlook 2007, the sniffer process does not run immediately after these messages arrive in your Inbox. There is always a small processing delay (up to a few minutes) as the sniffer process runs as an idle time task. This means Outlook waits for inactivity before kicking-off the sniffer process. In Outlook 2007 and later versions of Outlook, the sniffer process will run on items before they are displayed in your Inbox if you are using a profile configured with Cached Exchange mode. So, there is no processing delay in this configuration. However, these later versions of Outlook still exhibit a processing delay by the sniffer if you are using an Online mode profile with an Exchange mailbox.
The sniffer processs can be controlled by the Automatically process meeting requests and responses to meeting requests and polls setting in the Options dialog box, as shown in the following figure from Outlook 2010.
Collapse this imageExpand this image
If you disable this option, Outlook will not automatically process these items and processing of the items will only occur if you manually view the items (either by opening the item or viewing it in the Reading Pane). Therefore, it is not recommended you disable this option unless you prefer to manually process items.
The following items are the messages that are automatically processed by sniffer:
In the above registry key path x.0 represents your Outlook version (14.0 = Outlook 2010, 12.0 = Outlook 2007, and 11.0 = Outlook 2003)
Note: If the AutoProcReq registry value is either missing or set to a value of 1, the sniffer feature is enabled.
Article ID: 2699725 - Last Review: September 3, 2013 - Revision: 3.0