You Are Unable to Filter Between Two Internet Protocol Addresses in Network Monitor 2.0

View products that this article applies to.

This article was previously published under Q279354

Expand all | Collapse all

SYMPTOMS

After you set a capture filter in Network Monitor version 2.0 to filter between a pair of Internet Protocol (IP) addresses, no frames are captured. Also, this may occur even when there is IP traffic being sent to and from the IP addresses that you specified in the capture filter.

Back to the top

RESOLUTION

To resolve this problem, obtain the latest service pack for Windows 2000. For additional information, click the following article number to view the article in the Microsoft Knowledge Base:

260910 (http://support.microsoft.com/kb/260910/EN-US/ ) How to Obtain the Latest Windows 2000 Service Pack

The English version of this fix should have the following file attributes or later:

   Date       Time     Version        Size     File name
   -----------------------------------------------------
   11/10/00   10:58pm  5.0.2195.2709  37,488   Nmnt.sys

Back to the top

STATUS

Microsoft has confirmed that this is a problem in the Microsoft products that are listed at the beginning of this article. This problem was first corrected in Windows 2000 Service Pack 2.

Back to the top

MORE INFORMATION

For additional information about how to set capture filters in Network Monitor, click the article number below to view the article in the Microsoft Knowledge Base:

148942 (http://support.microsoft.com/kb/148942/EN-US/ ) How to Capture Network Traffic with Network Monitor

For additional information about how to install Windows 2000 and Windows 2000 hotfixes at the same time, click the article number below to view the article in the Microsoft Knowledge Base:

249149 (http://support.microsoft.com/kb/249149/EN-US/ ) Installing Microsoft Windows 2000 and Windows 2000 Hotfixes

Back to the top