Article ID: 281760 - View products that this article applies to.
This article was previously published under Q281760
IMPORTANT: This article contains information about editing the metabase. Before you edit the metabase, verify that you have a backup copy that you can restore if a problem occurs. For information about how to do this, see the "Configuration Backup/Restore" Help topic in Microsoft Management Console (MMC).
On a Windows 2000-based server that is running the SMTPSVC service with dual Network Interface Cards (NIC) installed, each bound to unique IP addresses as follows
NIC 1 --10.1.2.219 - third-party SMTP utility assigned to port 25 on this IP addresswhen you attempt to start the SMTP virtual server that is configured to use the 10.1.2.250 IP address bound to NIC 2 (not "All Unassigned") on Windows 2000, the following is recorded in the Application event log:
NIC 2 --10.1.2.250 - Windows 2000 SMTP service (Exchange 2000 is NOT involved)
Event Type: ErrorIf you telnet to the 250 address on port 25 while the virtual server is not running, you get no response. The third-party utility is not listening on that IP. You can stop the third-party software, and then the virtual server will start.
Event Source: SMTPSVC
Event Category: None
Event ID: 115
The service could not bind instance 1. The data is the error code.
0000: 40 27 00 00 @'..
If you run the netstat -an command, it returns the following information when the default virtual server is started:
TCP 0.0.0.0:25 0.0.0.0:0 LISTENINGThis shows that the SMTP virtual server is listening on all unassigned IP addresses even though you specified only the 10.1.2.250 IP address.
The SMTP service listens to port 25 on all unassigned IP addresses even if you specify a specific IP address for the default virtual server. You need to disable the Microsoft Internet Information Services (IIS) socket pooling feature (DisableSocketPooling). This property is not exposed in ADSI for SMTP.
The easiest way to resolve this issue is to download MetaEdit, and then set the value on the virtual service instance.
WARNING: If you edit the metabase incorrectly, you can cause serious problems that may require you to reinstall any product that uses the metabase. Microsoft cannot guarantee that problems that result if you incorrectly edit the metabase can be solved. Edit the metabase at your own risk.
NOTE: Always back up the metabase before you edit it.
Contact us for more help
Connect with Answer Desk for expert help.