Article ID: 293956 - Last Review: July 27, 2006 - Revision: 4.2

Visio2002: Error Message: "Error 1925. You Do Not Have Sufficient Privileges" Performing Setup with the /J Switch on NT 4.0

View products that this article applies to.
This article was previously published under Q293956
Expand all | Collapse all

SYMPTOMS

When you install Microsoft Visio 2002 using the /j command-line switch, you receive the following error message:
Error 1925. You do not have sufficient privileges to complete this installation for all users of the machine. Log on as administrator and then retry this installation.
NOTE: You receive this message even though you are logged on as administrator.
Back to the top

CAUSE

This issue may occur if you are installing Visio 2002 on a computer using the Microsoft Windows NT 4.0 operating system.
Back to the top

RESOLUTION

To work around this issue, install Visio without using the /j switch on the computer that is using Windows NT 4.0.
Back to the top

STATUS

Microsoft has confirmed that this is a problem in the Microsoft products that are listed at the beginning of this article.
Back to the top

MORE INFORMATION

For additional information about Setup command-line switches, click the article number below to view the article in the Microsoft Knowledge Base:
282119  (http://support.microsoft.com/kb/282119/EN-US/ ) Visio2002: Setup Command-Line Switches for Visio 2002
Back to the top
APPLIES TO
  • Microsoft Visio 2002 Standard Edition
  • Microsoft Visio 2002 Professional Edition
  • Microsoft Windows NT Workstation 4.0 Developer Edition
  • Microsoft Windows NT 4.0 Service Pack 6
  • Microsoft Windows NT 4.0 Service Pack 6a
Back to the top
Keywords: 
kbprb KB293956
Back to the top
 

Get Help Now

Contact a support professional by E-mail, Online, or Phone

Article Translations

 

Related Support Centers