Article ID: 296264 - View products that this article applies to.
This article was previously published under Q296264
By default, opportunistic locking is enabled for server message block (SMB) clients that run one of the Windows operating systems that is listed in the "Applies to" section. Opportunistic locking lets clients lock files and locally cache information without the risk of another user changing the file. This increases performance for many file operations but may decrease performance in other operations because the server that grants the opportunistic lock must manage the breaking of that lock when another user requests access to the file.
Notes for Windows Vista
Important This section, method, or task contains steps that tell you how to modify the registry. However, serious problems might occur if you modify the registry incorrectly. Therefore, make sure that you follow these steps carefully. For added protection, back up the registry before you modify it. Then, you can restore the registry if a problem occurs. For more information about how to back up and restore the registry, click the following article number to view the article in the Microsoft Knowledge Base:
(http://support.microsoft.com/kb/322756/ )How to back up and restore the registry in Windows
The location of the client registry entry for opportunistic locking has changed from the location in Microsoft Windows NT. In later versions of Windows, you can disable opportunistic locking by setting the following registry entry to 1:
OplocksDisabled REG_DWORD 0 or 1Note The OplocksDisabled entry configures Windows clients to request or not to request opportunistic locks on a remote file.
Default: 0 (not disabled)
You can also deny the granting of opportunistic locks by setting the following registry entry to 0:
EnableOplocks REG_DWORD 0 or 1Note The EnableOplocks entry configures Windows-based servers to allow or to deny opportunistic locks on local files. These servers include workstations that share files.
Default: 1 (enabled)
In addition, you can use the following values to tune opportunistic locking for Windows-based computers that have granted opportunistic locks.
The following value specifies the minimum link throughput that the server allows before it disables raw and opportunistic locks for this connection:
MinLinkThroughput REG_DWORD 0 to infinite bytes per secondThe following value specifies the maximum time that is allowed for a link delay. If delays exceed this number, the server disables raw I/O and opportunistic locking for this connection.
MaxLinkDelay REG_DWORD 0 to 100,000 secondsThe following value specifies the time that the server waits for a client to respond to an oplock break request. Smaller values allow detection of crashed clients more quickly, but might potentially cause loss of cached data.
OplockBreakWait REG_DWORD 10 to 180 secondsNote You must restart the computer for these registry changes to take effect.
Article ID: 296264 - Last Review: April 4, 2011 - Revision: 11.0
Contact us for more help
Connect with Answer Desk for expert help.