Article ID: 304488 - View products that this article applies to.
This article was previously published under Q304488
This article has been archived. It is offered "as is" and will no longer be updated.
This article contains comments, corrections, and information about known errors relating to the Microsoft Press book MCSE Training Kit: Microsoft Windows 2000 Advanced Server Clustering Services, ISBN 0-7356-1293-5.
The following topics are covered:
Pages 51 & 345: Correction To Question 6On pages 51 and 345, question 6,
"6. When you use Windows 2000 Advanced Server and Cluster Service, which of the following drive type are supported for the shared device?"
"6. When you use Windows 2000 Advanced Server and Cluster Service, which of the following technologies are supported for the shared device?"
Page 81: Remove Windows 2000 Datacenter ServerOn page 81, under Lesson Summary,
"This lesson explained how to perform rolling upgrades of a cluster from Windows NT 4 Enterprise Edition to Windows 2000 Advanced Server or Windows 2000 Datacenter Server."
"This lesson explained how to perform rolling upgrades of a cluster from Windows NT 4 Enterprise Edition to Windows 2000 Advanced Server."
Page 98: Incorrect Dependencies In Table 4.3On page 98, in Table 4.3,
"Generic Application - None
Generic Service - None"
"Generic Application - Network Name
Generic Service - Network Name"
Page 165: Incorrect Path In Figure 6.3Page 165, in Figure 6.3,
Page 211: Incorrect Statement About Possible OwnersOn page 211, in the eighth bulleted item,
"Check the Possible Owners list of the group and each resource to ensure..."
"Check the Possible Owners list of each resource to ensure..."
Page 335: Incorrect Information About Unexpected Manner Of Network TrafficOn page 335, in the top paragraph, change:
"Network traffic might be causing a large amount of collisions or might not consistently arrive at its intended destination. In this situation, the switch and the unicast network address are conflicting with each other. If you're using a switch to connect the hosts in your cluster configuration, NLB must be set to use multicast mode. If you cannot change the mode to unicast, you must connect your cluster hosts in some other way, perhaps with a hub or coaxial cable. Otherwise, you'll have to switch to multicast mode using the Cluster Parameters tab of the network load balancing properties dialog box."
"Network traffic might be causing a large amount of collisions or might not consistently arrive at its intended destination when connections are made across a switch to which the NLB virtual adapters are connected. This problem occurs because a large number of unknown unicast and multicast packets are being blocked on the port(s) of the switch. By default, NLB masks the source media access control (MAC) address on outbound packets, preventing switches from learning and forcing them to broadcast packets for unknown addresses to all ports.
"To resolve this issue, you can replace the switch with a hub, disable port blocking, add a static address to the MAC address table on the switch that maps to the virtual MAC address used by the NLB cluster, or modify the registry of each NLB cluster host to disable masking of the MAC address."
For further details on this issue, please refer to the following Microsoft Knowledge Base article:
Microsoft Press is committed to providing informative and accurate books. All comments and corrections listed above are ready for inclusion in future printings of this book. If you have a later printing of this book, it may already contain most or all of the above corrections.
Contact us for more help
Connect with Answer Desk for expert help.