Article ID: 314868 - View products that this article applies to.
This article was previously published under Q314868
For a Microsoft Windows 2000 version of this article, see 162326
This article describes TRACERT (Trace Route), a command-line utility that you can use to trace the path that an Internet Protocol (IP) packet takes to its destination.
This article discusses the following topics:
How to Use the TRACERT UtilityThe TRACERT diagnostic utility determines the route to a destination by sending Internet Control Message Protocol (ICMP) echo packets to the destination. In these packets, TRACERT uses varying IP Time-To-Live (TTL) values. Because each router along the path is required to decrement the packet's TTL by at least 1 before forwarding the packet, the TTL is effectively a hop counter. When the TTL on a packet reaches zero (0), the router sends an ICMP "Time Exceeded" message back to the source computer.
TRACERT sends the first echo packet with a TTL of 1 and increments the TTL by 1 on each subsequent transmission, until the destination responds or until the maximum TTL is reached. The ICMP "Time Exceeded" messages that intermediate routers send back show the route. Note however that some routers silently drop packets that have expired TTLs, and these packets are invisible to TRACERT.
TRACERT prints out an ordered list of the intermediate routers that return ICMP "Time Exceeded" messages. Using the -d option with the tracert command instructs TRACERT not to perform a DNS lookup on each IP address, so that TRACERT reports the IP address of the near-side interface of the routers.
In the following example of the tracert command and its output, the packet travels through two routers (188.8.131.52 and 184.108.40.206) to get to host 220.127.116.11. In this example, the default gateway is 18.104.22.168 and the IP address of the router on the 22.214.171.124 network is at 126.96.36.199.
C:\>tracert 188.8.131.52The output from the command:
Tracing route to 184.108.40.206 over a maximum of 30 hops --------------------------------------------------- 1 2 ms 3 ms 2 ms 220.127.116.11 2 75 ms 83 ms 88 ms 18.104.22.168 3 73 ms 79 ms 93 ms 22.214.171.124 Trace complete.
How to Use TRACERT to TroubleshootYou can use TRACERT to find out where a packet stopped on the network. In the following example, the default gateway has found that there is no valid path for the host on 126.96.36.199. Probably, either the router has a configuration problem, or the 188.8.131.52 network does not exist, reflecting a bad IP address.
C:\>tracert 184.108.40.206The output from the command:
TRACERT is useful for troubleshooting large networks where several paths can lead to the same point or where many intermediate components (routers or bridges) are involved.
Tracing route to 220.127.116.11 over a maximum of 30 hops ----------------------------------------------------- 1 18.104.22.168 reports: Destination net unreachable. Trace complete.
How to Use TRACERT OptionsThere are several command-line options that you can use with TRACERT, although the options are not usually necessary for standard troubleshooting.
The following example of command syntax shows all of the possible options:
tracert -d -h maximum_hops -j host-list -w timeout target_hostWhat the parameters do:
-d Specifies to not resolve addresses to host names -h maximum_hops Specifies the maximum number of hops to search for the target -j host-list Specifies loose source route along the host-list -w timeout Waits the number of milliseconds specified by timeout for each reply target_host Specifies the name or IP address of the target host