The Add Hardware Wizard Detects Turned-Off COM Ports in Windows XP

Article translations Article translations
Article ID: 323511 - View products that this article applies to.
This article was previously published under Q323511
For a Microsoft Windows 2000 version of this article, see 312291.
Expand all | Collapse all

SYMPTOMS

If you turn off (disable) a COM port in Device Manager and then run the automatic detection feature for the first time by using the Add Hardware Wizard, the COM port that you turned off is detected as new hardware. This problem occurs if your computer uses Advanced Configuration and Power Interface (ACPI).

CAUSE

Because of the various types of COM port implementations on existing computers, Windows has to enumerate COM ports in various ways for compatibility reasons. Windows must check the COM port devices for duplicates to avoid conflicts with other devices.

If you turn off an ACPI COM port in Device Manager, Windows cannot detect the resource conflict; the COM port is regarded as new hardware when the you run the Add Hardware Wizard.

WORKAROUND

This problem typically does not occur until you restart the computer. To work around this problem, do not click Install Communication Port when the COM port is detected by the Add Hardware Wizard. If you install the port, an additional incorrect COM port is added in Device Manager.

To clear the incorrect COM ports in Device Manager, delete all the inactive COM ports in Device Manager. The next time that you start your computer, the COM ports are detected correctly.

Properties

Article ID: 323511 - Last Review: May 29, 2007 - Revision: 1.3
APPLIES TO
  • Microsoft Windows XP Professional
  • Microsoft Windows XP Home Edition
Keywords: 
kbenv kbprb KB323511

Give Feedback

 

Contact us for more help

Contact us for more help
Connect with Answer Desk for expert help.
Get more support from smallbusiness.support.microsoft.com