STOP Error Occurs When You Restore Backup Windows XP SP1 Files

Article translations Article translations
Article ID: 328035 - View products that this article applies to.
This article was previously published under Q328035
Expand all | Collapse all

SYMPTOMS

After you restore a full backup of a Windows XP installation, you may receive the following Stop error message:
STOP: 0xc0000139
Entry Point Not Found

The procedure entry point LdrEnumerateLoadedModules could not be located in the dynamic link library Ntdll.dll.
After you receive this error message, the computer may automatically restart. After this error message occurs, you may not be able to start the computer in Safe mode.

CAUSE

This problem may occur in the following scenario:
  1. You install Windows XP Service Pack 1 (SP1) on the computer.
  2. You use the Microsoft Backup Utility to back up files and settings.
  3. You remove Windows XP SP1 from the computer.
  4. You use the Microsoft Backup Utility to restore files and settings from the backup file.

RESOLUTION

To prevent this problem from occurring, make sure that Windows XP SP1 is installed before you use the Microsoft Backup Utility to restore files and settings from the backup file (if the backup file was created while Windows XP SP1 was installed).

If you have already restored the backup file and you are experiencing this problem, use the following procedure to repair your installation of Windows XP:
  1. Insert the Windows XP CD in the CD-ROM or DVD-ROM drive, and then restart your computer.
  2. When you are prompted to start your computer from the CD, do so.

    NOTE: You must be able to start your computer from the Windows XP CD to run Windows Setup. Your CD-ROM or DVD-ROM drive must be configured to do so. For information about how to configure your computer to start from the CD-ROM or DVD-ROM drive, see the documentation that is included with your computer or contact your computer manufacturer.
  3. After Setup starts, press ENTER to continue the Setup process.
  4. Press ENTER to select To set up Windows now, press ENTER. Do not select Recovery Console.
  5. Press F8 to accept the licensing agreement.

    Setup searches and finds your installation of Windows XP, and you receive the following message:
    If one of the following Windows XP installations is damaged, setup can try to repair it. Use the up and down arrows to select an installation. To repair the selected installation, press R. To continue without repairing, press ESC.
  6. Select the appropriate Windows XP operating system installation, and then press R to repair it.
  7. Follow the instructions that appear to repair the installation.
  8. After the repair process has been completed, install Windows XP SP1.
  9. Restore the backup file.NOTES:
    • You may have to change the boot drive sequence in your BIOS settings to successfully start your computer from the Windows XP CD. Contact the manufacturer of your computer or see your manufacturer's documentation, for more information.
    • After you repair your Windows XP installation, you may have to reactivate your copy of Windows XP.

STATUS

Microsoft has confirmed that this is a problem in Windows XP.

MORE INFORMATION

This problem does not occur if you use the Automated System Recovery (ASR) Wizard to create the backup, and then restore the backup by using ASR.

Properties

Article ID: 328035 - Last Review: September 4, 2002 - Revision: 1.2
APPLIES TO
  • Microsoft Windows XP Professional SP1
  • Microsoft Windows XP Home Edition SP1
  • Microsoft Windows XP 64-Bit Edition SP1
Keywords: 
kbprb KB328035

Give Feedback

 

Contact us for more help

Contact us for more help
Connect with Answer Desk for expert help.
Get more support from smallbusiness.support.microsoft.com