MS-DOS: Piped DIR Command Shows Temporary Files

Article translations Article translations
Article ID: 74166 - View products that this article applies to.
This article was previously published under Q74166
This article has been archived. It is offered "as is" and will no longer be updated.
Expand all | Collapse all

Summary

Temporary files having a zero byte size can be seen if the DIR command is issued with a pipe symbol and parameters MORE or SORT. These files are seen when the DIR command is listing files residing in the temporary directory.

If the temporary directory is set to be: C:\windows\temp and the current directory is C:\windows\temp, then the following examples of commands will show the temporary DOS files:
dir | more
dir | sort
The files can also be seen if the current directory is not the temporary directory by including a path as shown below:
dir C:\windows\temp | more
dir \windows\temp |sort
The files will appear as eight-character files with no file extensions. They will have zero bytes and will be stamped with the date and time that the command was given, as follows:
AOBOAJCF 0 7-04-91 2:45p
AOBOAJCK 0 7-04-91 2:45p.


If you don't use the pipe parameter, these files will not be visible. They are temporary and are deleted immediately after the command is finished executing.

This information applies to MS-DOS version 5.0. In versions previous to 5.0, the temporary files were not created in the directory specified by the temp variable, but rather in the root directory of the active drive.

Properties

Article ID: 74166 - Last Review: November 2, 2013 - Revision: 4.0
Applies to
  • Microsoft MS-DOS 5.0 Standard Edition
  • Microsoft MS-DOS 6.0 Standard Edition
Keywords: 
kbnosurvey kbarchive KB74166

Give Feedback

 

Contact us for more help

Contact us for more help
Connect with Answer Desk for expert help.
Get more support from smallbusiness.support.microsoft.com