Article ID: 822585 - Last Review: October 25, 2007 - Revision: 2.2

Internet Mail Wizard Displays the IP Address 0.0.0.0 When a Network Adapter Is Disabled

View products that this article applies to.
System TipThis article applies to a different operating system than the one you are using. Article content that may not be relevant to you is disabled.

Expand all | Collapse all

SYMPTOMS

When you run Internet Mail Wizard on a server that has two network adapters that use static IP addresses on separate subnets, on the Create two SMTP virtual servers page, you may find that the IP Address of one of the network adapters that is installed on the server is shown as 0.0.0.0.
Back to the top

CAUSE

This behavior occurs when you run Internet Mail Wizard and either of the following conditions are true:
  • A network adapter is disabled.
  • A network cable is disconnected.
Back to the top

RESOLUTION

Make sure that all network adapters are enabled and are functioning correctly before you run Internet Mail Wizard.
Back to the top

REFERENCES

For more information about Exchange Server 2003, see the following Microsoft Web sites:
http://technet.microsoft.com/en-us/library/bb123872.aspx (http://technet.microsoft.com/en-us/library/bb123872.aspx)

Back to the top
APPLIES TO
  • Microsoft Exchange Server 2003 Enterprise Edition
  • Microsoft Exchange Server 2003 Standard Edition
Back to the top
Keywords: 
KB822585
Back to the top